Table of Contents
Advertisement
8 Test Mode
8.1.
Utility
8.1.1.
Utility-Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results can be saved as a TXT-format
(text) file.
When testing is complete, any cards that were set to OUS status must be returned to INS status if they are to be used again.
8.1.1.1.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary according to the type of card
being tested.
The tests that are performed on each card are as follows:
Local loop back diagnosis
Card CT bus diagnosis
DTMF Receive test port
PT loop back diagnosis
DSP DTMF generator/receiver diagnosis
DSP DTMF receiver diagnosis
Framer IC alarm signal detection diagnosis
Framer IC error detection diagnosis
CS-INF loop back diagnosis
Caller ID card loop back diagnosis
Extension mode setting test
To perform a card test
1. From the Utility menu, select Diagnosis.
2. Click on the Status cell of the card to be tested, and set it to "OUS".
3. Click on the cell showing the card type.
A new window will be displayed.
4. Select the Card Test option.
A new window will be displayed.
5. Click OK to perform the test(s).
The error report will be displayed. When all tests are completed, the words "Test End!" will be shown on the last line of the out-
put.
6. Select an option:
• Click Capture if you want to save the displayed information.
1. Enter a file name, or select a file to overwrite.
2. Click Save.
• Click Cancel to return to the Diagnosis screen.
DHLC
DLC
SLC
X
X
X
X
X
X
X
X
X
X
41
LCOT
T1
E1
BRI
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
KX-NCP500GR
PRI
OPB
X
X
X
X
X
X
X
X
Advertisement
Table of Contents
