Sony DVP-F35P Operating Instructions Manual page 24

Connecting to an AV amplifier (receiver) with a digital input jack, and a
D
decoder (Dolby Digital, MPEG audio or DTS), and 6 speakers
This connection will allow you to use the Dolby Digital, MPEG audio or DTS decoder function
of your AV amplifier (receiver).
[Speakers]
Rear (L)
Rear (R)
l: Signal flow
z Hint
Use connection
more speakers (6.1 ch or more).
Notes
• After you have completed the connection, be sure
to set "DOLBY DIGITAL" to "DOLBY
DIGITAL" and "DTS" to "ON" in Quick Setup
(page 25). If your AV amplifier (receiver) has an
MPEG audio decoder function, set "MPEG" to
24
CD/DVD player
to DIGITAL OUT
(COAXIAL or OPTICAL)
Optical digital cord
(not supplied)
Remove jack cap
before connecting
to optical digital input
AV amplifier (receiver) having
a decoder
Subwoofer
D when connecting to 7 or
COMPONENT
VIDEO OUT
DIGITAL OUT
Y P B /C B P R /C R
PCM/DTS/MPEG/
DOLBY DIGITAL
OPTICAL COAXIAL R-AUDIO OUT-L
D
DIGITAL OUT
PCM/DTS/MPEG/
DOLBY DIGITAL
OPTICAL COAXIAL
or
to coaxial digital input
"MPEG" (page 72). Otherwise, no sound or a
loud noise will come from the speakers.
• In order to listen to DTS sound tracks, you must
use this connection. DTS sound tracks are not
output through the AUDIO OUT L/R jacks, even
if you set "DTS" to "ON" in Quick Setup
(page 25).
• When you connect an amplifier (receiver) that
conforms to the 96 kHz sampling frequency, set
"48kHz/96kHz PCM" in "AUDIO SETUP" to
"96kHz/24bit" (page 72).
VIDEO OUT
NORMAL
PROGRESSIVE
S VIDEO OUT
Coaxial digital cord
(not supplied)
[Speakers]
Front (L)
Centre
Front (R)