NEC DLP Cinema NC3541L Installation Manual page 87

LCD Menu
[LD Calibration]
Calibrate the light source to save light source adjustment data into the main body.
This function can be used only when the main body is on standby.
Use this function only if necessary.
[S/N Maintenance]
Use the function to maintain the main body serial number when replacing a board in the main body during maintenance, etc.
This menu can be used only during standby.
[LD Date Copy]
Use the function to maintain the light source adjustment data of the main body after replacing a board in the main body during
maintenance, etc.
This menu can be used only during standby.
For details, refer to the service manual.
[Shadow Adj.]
Use the function to adjust shadow. This menu can be used only during standby.
On the confirmation screen shown by pressing the ENTER button, selecting "Yes" and pressing the ENTER button automati-
cally starts up the projector to project an entirely white image. During the use of this function, the output of the light source
cannot be adjusted (Light Setup).
[Lens Mount Adj.]
Use the function to adjust the lens mount (focus balance adjustment).
This menu can be used only during standby.
On the confirmation screen shown by pressing the ENTER button, selecting "Yes" and pressing the ENTER button automati-
cally starts up the projector to project a green cross-hatching image. During the use of this function, the output of the light
source cannot be adjusted (Light Setup).
112
← Pressing the ENTER button executes this function.
← Pressing the ENTER button executes this function.
← Pressing the ENTER button executes this function.
← Pressing the ENTER button executes this function.