NEC DLP Cinema NC3541L Installation Manual page 40

Setting Up Your Projector
Input Selection
The power supply connection method is configured by the wiring to the input selection. The configurations are as follows.
AC power supply cable
• For the AC power cable, use a cable of thickness as appropriate for the installation country and made of copper as shown
below.
• Use a round type UL-listed solderless terminal for the section connected to the main unit. In addition, when clamping this
terminal with the cable, use an UL listed tool.
Compatible Cables and Solderless Terminals
The specifications of the terminals for attaching the power cables are as follows.
The size of the solderless terminal to use and the fastening torque of the screws varies depending on the type of terminal block.
Use the cable and solderless terminal that is suitable for the specific type of terminal block as shown in the following table.
This specifies the model name of the recommended solderless terminals. Use these parts or equivalent parts. If you are unable
to use the recommended solderless terminals, ensure that you use terminals of the dimensions shown in the following
diagram.
50
Power supply terminal L, N
C1 Connection
C2
Connection
Grounding terminal G