NEC DLP Cinema NC3541L Installation Manual page 43

Connecting the cable
In order to attach the power cable to the connector block, connect the wires using the following procedure such that the indi-
vidual wires cannot directly touch each other.
1
Remove the power cable sleeves from the terminals to
ensure that the sleeves are not pinched by the terminal
attachment screw.
Pull back the sleeves from the terminal area before fastening the
screw to prevent the sleeves from being pinched.
2
Attach the sleeves after tightening the screw.
Tighten the fixing screw to the designated torque.
Use sleeves and secure the insulation to ensure that terminals do not
touch each other. If the cables are attached to the power supply terminal
without using sleeves, there is a risk of the terminals touching each other
as shown in the photograph on the right.
Setting Up Your Projector
Sleeves
53