Siemens SIMATIC IPC127E Operating Instructions Manual page 50

Device maintenance and repair
5.4 Replacing the SSD
Installing the SSD
To install the new backup battery, follow these steps:
1. Place the heat sink
2. Insert the SSD including heat sink into the plug connector.
3. As shown in the figure, the heat sink must rest on the enclosure. Check the position of the
heat sink by carefully sliding the module back into the enclosure. Correct the position of
the heat sink, if necessary.
4. Position the spring
rest above the screw sleeve; then fasten the SSD again with the screw.
5. Close the enclosure again. To do so, proceed in the reverse order of the removal.
50
② ①
on the SSD .
③
in the heat sink so that the ring-shaped part of the spring comes to
Operating Instructions, 01/2019, A5E44296915-AA
SIMATIC IPC127E