Aiwa CX-NA50 Operating Instructions Manual page 31

The unit can be turned on at a specified time every day with the built-in timer.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1 Press the TIMER button while pressing the SHIFT button once to display
within 4 seconds.
¥
is displayed, and the hour flashes.
NOTE
If you press the SET button after 4 seconds, another operation may start.
2 Designate the hour of the timer-on time by pressing the
button. Repeat to designate the minute of the timer-on time.
After you designate the timer-on time, one of the source name flashes on the display for 4 seconds.
3 Within 4 seconds, press the FUNCTION button to select a source.
The selected source name flashes for 4 seconds. At this time, the selected function button does not light up.
• If this step is not completed within 4 seconds, repeat from step 1.
• If the TUNER button is pressed, the band cannot be selected in this step.
CLOCK AND TIMER (cont.)
4 Within 4 seconds, select the duration for the timer-activated period with the
button.
The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.
• If this step is not completed within 4 seconds, repeat from step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on try 1.
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station,
6 Press the POWER button to turn the unit off after adjusting the volume and tone.
¥
remains on the display after the power is turned off (timer standby mode.)
When the timer-on time is reached, the unit turns on and begins play with the selected source.
• The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more.
¥
, and press the
DOWN or UP button, and the
pg. 20
DOWN or
SET button
SET
UP