Aiwa CX-NA50 Operating Instructions Manual page 15

Load discs.
To play all discs in the disc compartment, press the button.
Play begins with the disc on tray 1.
To play one disc only, press one of the DISC DIRECT PLAY buttons.
The selected disc is played once.
To stop play, press the button.
To pause play, press the button. To resume play, press again.
To search for a particular point during playback, keep the or button pressed and release the button at
the desired point.
To skip to the beginning of a track during playback, press the or button repeatedly.
To remove discs, press the OPEN/CLOSE button.
To start play when the power is off (Direct Play Function)
Press the CD button. The power turns on and play of the loaded disc begins.
When the OPEN/CLOSE button is pressed, the power is also turned on.
To check the remaining time
During play, press the CD EDIT CHECK button on the main unit or the EDIT/CHECK button on the remote control
while pressing the SHIFT button. The amount of time remaining until all tracks finish playing is displayed. To
restore the playing time display, repeat the above again.
Selecting a track with the remote control
1 Press one of the DISC DIRECT PLAY buttons to select a disc.
2 Press the numbered buttons and the +10 button to select a track.
Example:
To select the 25th tack, press the +10, +10 and 5 buttons.
To select the 10th track, press the +10 and 0 buttons.
The selected track starts to play and play continues to the end of that disc.
Replacing discs during play
While one disc is playing, the other discs can be replaced without interrupting play.
1 Press the DISC CHANGE button.
2 Remove the discs and replace with other discs.
3 Press the OPEN/CLOSE button to close the disc compartment.
NOTE
• When loading an 8-cm (3-inch) disc, put it onto the inner circle of the tray.
• Do not place more than one compact disc on one disc tray.
• Do not tilt the unit with discs loaded. Doing so may cause malfunctions.
CD PLAYING (cont.) pg. 10