Table of Contents
Advertisement
Remove the transport strut.
4.
Hose and cable lengths
Left-hand connection
■
Right-hand connection
■
*depending on the model
If the supply hose is too short for
Tip:
your connection, you can order an
extension from the after-sales service.
Positioning and connecting
Water inlet
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Observe the following when connecting
the machine:
Notes
Only operate the washing machine
■
using cold mains water.
Do not connect the machine to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied with
the machine or one that was
purchased from an authorised
retailer.
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 0.1 MPa (1 bar)
Maximum 1 MPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
en
15
Advertisement
Table of Contents
