Adjusting The Handle; Securing Child - Graco SNUGRIDE I-SIZE Owner's Manual

Adjusting the handle

14
Squeeze latches on both sides at bottom of
handle to release it.
Rotate handle until it clicks into any of the 4
positions:
Position A (up): MUST be used when carrying
by handle,
Position B: Vehicle Travel Position
Position C: Convenience Position
Position D (down): is the sitting position.
Always place handle in the B position when
using it in a vehicle.
15
Canopy Mesh Opening
To open mesh canopy opening, unzip as shown.

Securing Child

16
Loosen Harness Straps
Push down on the harness release lever while
pulling out on the harness straps.
17
Press the red button on the harness to unfasten
18
Place Your Child in the Seat
back.
19
Place Harness Straps Over Child's Shoulders
20
Be Sure the Harness Straps are at the
Proper Height
Harness straps must be at or just below the
child's shoulders.
To change harness location, from the back of the
21
seat, squeeze the headrest adjustment buttons
and move it up or down to the correct harness
position.
22 Buckle Harness Straps
Fit the two buckle tongues together and push
them into the buckle. You will hear a "click" when
buckle tongues are securely attached. Pull up
on the buckle tongue to make sure it is securely
attached.
23
Pull All the Slack Out From around the
Waist
Pull up on the harness strap while pushing the
buckle tongue down. Do this on both sides.
EN
15