About Suitable Specification Of Speaker - Pioneer GM-D9705 Owner's Manual

(_c_o_n_n_e_d_i_n-=-g_t_he_u_n_it_s __ )
For bridged mode for a two-channel amplifier,
with a
4n
load, either wire two
sn
speakers
in parallel, Left
EB
and Right
8
(Diagram A) or
use a single
4n
speaker. For other amplifiers,
please follow the speaker output connection
diagram for bridging shown on rear: two
sn
speakers in parallel for a
4Q
load or a single
4n
speaker per channel.
In addition, refer to the speaker instruction
manual for information on the correct connec-
tion procedure.
• For any further enquiries, contact your local
authorized Pioneer dealer or customer
service.(!]
About suitable
specification of speaker
AcAUTION
Be sure to connect the subwoofer to the subwoo-
fer output terminal of this unit, and speakers
other than the subwoofer to the speaker output
terminal of this unit.
Ensure speakers conform to the following
standards, otherwise there is a risk of fire,
smoke or damage. Speaker impedance is 2
.n
to 8
.n,
or 4
.n
to 8
.n
for two-channel and other
bridge connections.
Subwoofer
• Nominal input:
Min. 350W / 4 .Q
Min. 600W /2 .Q
Other than subwoofer (4
.n)
Four-channel output
Max. input:
Min. 150W
Two-channel output
Max. input:
Min.400W
En
(
______
)
Connecting the car stereo
Connect the RCA output jack of the car stereo
to the RCA input jack of the amplifier, or con-
nect the speaker output wire from the car
stereo to the speaker input terminal of the am-
plifier.
CH-A input (Two-channel input)
• Slide the
2CH-4CH INPUT SELECT
(input
select) switch to the
2CH
position.
• Slide the
A/B-SW INPUT SELECT
(input se-
lect) switch to the
A/B
position.
G)
2CH 4CH
L ~
ll[CJ
INPUT SELECT
@
;:I
O
:1a1f,;
l
-•FJ ~
----ii
1
mi~
~ @
A /8 SW
@
CD
2CH-4CH INPUT SELECT (input select) switch
(2CH position)
®
RCA input jack A
@ From car stereo (RCA output)
If only one input plug is used, e.g. when the
car stereo has only one output (RCA output),
connect the plug to RCA input jack
A.
©
Connecting wires with RCA plugs (sold sepa-
rately)
@ A/B-SW INPUT SELECT
(input select) switch
(A/B
position)
Notes
• For detai Is on the speaker output, refer to Con-
necting the speakers.
• When the
2CH-4CH INPUT SELECT
(input se-
lect) switch is set to 2CH, do not connect any-
thing to RCA input jack B.