Setting 40Gbase-X For 100G Sfp+ Port; Changing Password - Planet Networking & Communication XGS-6350-24X4C Quick Installation Manual

4.4 Setting 40GBASE-X for 100G SFP+ Port
The Managed Switch supports both 40GBASE-X and 100GBASE-X SFP
transceivers by manual setting and the default SFP+ port speed is set to 100Gbps.
For example, to establish the fiber connection with 40GBASE-X SFP transceiver in
the cgigaethernet 0/1, the following command configuration is required:
Switch#config
Switch_config#interface cgigaethernet 0/1
Switch_config_cg0/1#speed 40000
Switch_config_cg0/1#exit
Switch_config#interface range cgigaethernet 0/2-4
Switch_config_if_range#speed 40000
Switch_config_if_range#

4.5 Changing Password

The default password of the switch is "admin". For security reason, it is
recommended to change password and the following command configuration is
required:
Switch#config
Switch_config#username admin password planet2018
Switch_config#
Figure 4-8 Changing Password Interface Screen
10
Figure 4-7 Setting 40GBASE-FX Screen