BATTERY INSPECTION
Inspection and Verification
1. Verify that the customer concern by operating the system.
2. Visually inspect for obvious signs of mechanical or electrical damage.Visual Inspection Chart
Mechanical
Battery
•
Battery mounting
•
3. If an obvious cause for a concern is found, correct the cause before proceeding to the next step.
4. If the fault is not visually evident, proceed to the pin point test.
Battery Condition Test
NOTE:
Failure to fully charge the battery before retesting may cause false readings.
•
Pin point test
1. Verify the battery condition using the Battery Analyzer.
If the meter read, GOOD BATTERY, inspect the generator. (See GENERATOR INSPECTION
•
.)
If the meter read, GOOD-RECHARGE, charge the battery and inspect the generator. (See
•
GENERATOR INSPECTION .)
If the meter read, CHARGE & RETEST, fully charge the battery and retest.
•
If the meter read, REPLACE BATTERY, install a new battery.
•
If the meter read, BAD CELL-REPLACE, install a new battery.
•
Battery
Electrical
Battery cables
•
Battery posts
•
(w)
Engine Specifications
Page 203