CHARCOAL CANISTER
CHARCOAL CANISTER INSPECTION
1. Remove the charcoal canister. (See EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
REMOVAL/INSTALLATION .)
2. Plug ports A and C, then blow air into port B.
CAUTION:
Do not apply the pressure more than 20 kPa {0.2 kgf/cm
•
Doing so will damage the charcoal canister.
3. Verify that there is no air leakage from the case.
If not as specified, replace the charcoal canister.
•
2
, 2.8 psi} to the charcoal canister.
(w)
Engine Specifications
Page 194