Setting The Flap Separately (When Setting The Cz-Rtc2) - Panasonic U-8ME1E81 Service Manual

3. Detailed Settings Function

Setting the Flap Separately (When setting the CZ-RTC2)

1) The 4-air outlet flap can be adjusted separately during
operation. When not adjusted separately, all flaps operate
in the same manner.
Air discharge
port
(adjustment for up-down airflow direction)
<Procedure>
Stop the system before performing these steps.
1 Press and hold the
simultaneously for 4 seconds or longer.
2 If group control is in effect, press the
button and select the address (unit No.) of the
indoor unit to set. At this time, the fan at the indoor
1
unit begins operating.
3 " ," unit No. "
group control), item code "
" " are displayed blinking on the remote
2
controller LCD display.
4
Designate the item code "
Temperature Setting
3
Flap 1
4
Flap 2
=91
5
6
7
8
Flap
and buttons
,
" (or " " in the case of
," and settings data
" by adjusting the
/ buttons.
Electrical component box
=90
Flap 4
=93
Flap 3
=92
5 Press the timer time
the desired setting data.
Flap position
5
* Setting data "
Setting data Flap position during operation
Without separate setting
Swing
Move to position 1 and stay
Move to position 2 and stay
Move to position 3 and stay
Move to position 4 and stay
Move to position 5 and stay
When the flap position is set to 4 or 5 and the unit
is in the cooling or dry mode, the flap position is moved
to 3 and the operation is started. (refer to Fig. 2-4)
NOTE
The flap swings during the operation under "Setting the
Flap Separately".
At this time, the unselected flaps are moved to the
position 1 . (refer to Fig. 2-4)
6 Press the button.
(The display stops blinking and remains lit, and setting
is completed.)
If you wish to change the selected indoor unit, follow
the step 2 .
7 Press the
button to return to normal remote
controller display.
7
6
1
2-8
2WAY SYSTEM
Remote Controller Functions
/ buttons to select
1
2
3
4
Fig. 2-4
" (refer to Fig. 2-4)
3
2
4
5