Rear Disc Brake - Subaru Impreza 2002 Service Manual

PARKING BRAKE ASSEMBLY (REAR DISC BRAKE)
4. Parking Brake Assembly

(Rear Disc Brake)

A: REMOVAL
1) Remove the two mounting bolts and remove the
disc brake assembly.
(1) Disc brake assembly
2) Suspend the disc brake assembly so that the
hose is not stretched.
3) Pull down and release the parking brake.
4) Remove the disc rotor.
NOTE:
If the disc rotor is difficult to remove, try the follow-
ing two methods in order.
(1) Turn the adjusting screw using a slot-type
screwdriver until brake shoe gets away enough
from the disc rotor.
(1) Adjusting screw
(2) Cover (rubber)
(3) Slot-type screwdriver
(4) Back plate
(2) If the disc rotor seizes up within hub, drive
the disc rotor out by installing an 8-mm bolt in
holes B on rotor.
5) Remove the shoe return spring from parking
brake assembly.
6) Remove the front shoe hold down spring and pin
S4M0459A
with pliers.
7) Remove the strut and strut spring.
8) Remove the adjuster assembly from parking
brake assembly.
9) Remove the brake shoe.
10) Remove the rear shoe hold-down spring and
pin with pliers.
11) Remove the parking cable from parking lever.
S4M0463A
12) Using a standard screwdriver, raise the retain-
er. Remove the parking lever and washer from
brake shoe.
PB-9
(1) Parking brake cable
(2) Parking brake lever
PARKING BRAKE
G4M0383
BR0055
B4M1774B