ASSEMBLY OF THE
CLUTCH ASSEMBLY
-► 4-
Install or Connect (Figures 2, 3, and 9)
Tools Required:
J 6435 External Snap Ring Pliers
J 29640 Shaft Protector
J 29886 Driver Handle
J 37872 Spanner Wrench
J 38467 Bearing Remover and Installer
Figure 8— Removing the Coil Snap Ring
o
<
~
Figure 9— Installing the Rotor Pulley
1. Clutch coil and snap ring retainer.
• The coil flange protrusions must match the hole
in the front housing to prevent coil movement
and to correctly place the lead wire.
----- J 29886
J 38467
F9443