Camtraptions PIR V3 Manual page 6

remove the battery holder by unscrewing the two screws that secure it to the
enclosure.
The jumpers are located in the top right corner under the Camtraptions logo
and are labeled A, B, C and D. Place a connector so that it bridges the two
jumper pins to set the state to On. Place the connector so that it is mounted
on just one side, to set the jumper state to Off.
Important: when pulling up the jumper connectors, ensure the board is pushed
down so that it does not come away from the enclosure. If the board lifts from
the enclosure, the o-rings that seal the dials may pop off.
The power-up LED flash sequence provides a simple way to check the state
of the jumpers without removing the battery enclosure. See LED Indicator for
more.
The images below show example jumper placements:
Left: Jumpers A to D in the Off position with jumper connectors stowed on just the right pin.
Right: Jumper A in the On position (jumper connector spanning left and right pins) and
Jumpers B to D in the Off position (this time with jumper connectors stowed on the left pin).
Camtraptions PIR Motion Sensor v3 Manual Page 6