Central Machinery 90597 Assembly And Operating Instructions Manual page 6

14. Cut only the proper type of material. Never cut ferrous metals or masonry. The
abrasive particles generated will damage the saw..
15. Protect the electrical supply line with at least a 15 ampere time-delay fuse or circuit
breaker.
16. Make certain the blade rotates in the correct direction, with the teeth at the bottom of
the blade pointing to the rear of the Miter Saw.
17. Be sure that all clamp handles are tight before starting any operation.
18. Check that all blade and clamp washers are clean and recessed sides of collars are
against the blade. Tighten arbor screw securely.
19. Keep saw blade sharp and properly set.
20. Keep motor air slots free of chips and dirt.
21. Use blade guards at all times.
22. Support long stock with an outboard tool rest (not included).
23. Do not use blades that are smaller or larger than 10 inches, and rated less than 5200
RPM.
24. Do not wedge anything against fan to hold motor shaft.
25. Do not force the cutting action; stalling of the motor can cause major damage. Allow
motor to reach full speed before cutting.
26. Do not allow anyone to stand behind the saw during operation.
27. Do not apply lubricants to the blade while it is running.
28. Never place hands in the saw area (around, behind, or underside) while the unit is
running, or when only connected to the power source. Always unplug unit before
handling.
29. Do not perform any action freehand.
30. Do not move either hand from the saw or workpiece, or raise the arm until the blade
has stopped.
31. Do not use without the kerf plate, or when kerf slot is wider than 3/8 inch.
32. Removal of the material clamp is necessary if an angled cut would interfer with the
clamp.
SKU 90597 Page 6
REV 12/03