Table of Contents
Advertisement
C. Ventilator heat transfer wheels should rotate
slowly (49 RPM). Intake and exhaust blowers
should run and indoor comfort blower should
run.
D. De-energize the "A" terminal. The energy
recovery wheels, fresh air, exhaust air and
indoor comfort blowers should stop.
E. This completes ventilator checkout.
13. Re-install the blower access and filter access panels
at top of unit and secure with sheet metal screws.
INSERT FLANGE THRU SLOT IN DOOR AND
PUSH FLANGE UNDER INSULATION
FILTER
ACCESS
PANEL
Manual 2100-701
Page
10 of 16
FIGURE 5
Install Fresh Air Intake Hood Assembly
INSULATION
FRESH AIR INTAKE
HOOD AND FILTER
ASSEMBLY
FILTER ACCESS
SCREW
REPLACE SERVICE ACCESS PANEL AND
INSTALL FRESH AIR INTAKE HOOD
ASSEMBLY AS SHOWN
14. Replace the vent option access panel with the new
panel provided. Attach air intake hood with screws
provided (see Figure 5). Be sure to insert the top
flange of the air intake hood into and through the
slot of the service door and between the door and
insulation to prevent bowing of the door.
15. Apply Certification label, included with installation
instructions, next to unit serial plate.
16. Ventilator is now ready for operation.
Advertisement
Table of Contents
