Panasonic KX-UDS Series Step By Step Installation page 45

6.1 PS Registration <Step3> : Operation from PS to register

For unregistered PSs

MON. MENU

1. Display the standby screen above.

2. Hold down [OK] until "Please wait..." is displayed.

3. When registration has completed, "Registered" will be displayed.

Note

• You can register multiple PSs continuously. However, PS Registration mode will

terminate if no registrations are detected within 2 minutes.

(In case IPEI is registered by provisioning , there is no limit these 2 minutes.)

All CSs controlled by the Super Master CS will enter PS Registration mode at the

same time as the Super Master CS. You can register an PS to any of the CSs.

• Perform the registration procedure on each PS individually.

Performing the registration procedure on multiple PSs at the same time

may result in an error. In this case, perform the registration procedure again.

• After registering PSs, the Web port will be closed.

See "Appendix A" to open the Web port again.

Table of Contents

Kx-udt series