Requirements For Use; Project Engineering; Programming - Siemens CM 1542-5 Operating Instructions Manual

Product overview, functions

2.5 Requirements for use

2.5 Requirements for use
2.5.1

Project engineering

Configuration
For configuring the CM the following version of STEP 7 is required:
STEP 7 version
STEP 7 Professional V14
Downloading configuration data
When the configuration data is loaded on the CPU, the CM is supplied with the relevant
configuration data. The configuration data can be downloaded to the CPU via PROFIBUS or
any PROFINET interface of the S7-1500 station.
2.5.2

Programming

Programming
For programming the CM the following version of STEP 7 is required:
STEP 7 version
STEP 7 Professional V14
Use of FDL
For programming and using FDL, the following minimum firmware versions are required.
● CM: V2.0
● CPU: V2.0
18
Functions of the CM
The full functionality of the CP 1542-5
(6GK7 542-5DX00-0XE0) can be configured.
Functions of the CM
The full functionality of the CP 1542-5
(6GK7 542-5DX00-0XE0) can be programmed.
Operating Instructions, 11/2018, C79000-G8976-C290-04
CM 1542-5