Unpacking And Setting Up The Vehicle - KTM 85 SX 2018 Setup Instructions

2.1

Unpacking and setting up the vehicle

–
Open the box.
–
Remove the cable tie and wooden frame.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you have
finished.
–
Remove the separate enclosure and unpack it. Check that the
E00850-10
scope of supply is complete using the enclosed packing list.
–
Have a lift stand available.
Lift stand (78929955100)
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
402050-01
–
Loosen screws
wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten the screw of the wheel spindle
Guideline
Screw, front wheel
spindle
V01038-10
–
Position the fender. Mount and tighten the screws.
Guideline
Remaining screws,
chassis
V01039-01
–
Unpack the shock absorber.
–
Position the shock absorber. Mount and tighten the screws.
Guideline
Screw, top
shock absorber
Screw, bottom
shock absorber
V01040-01
1
and remove wheel spindle. Lift the front
M20x1.5 35 Nm (25.8 lbf ft)
M6 10 Nm (7.4 lbf ft)
M12 60 Nm (44.3 lbf ft)
M12 60 Nm (44.3 lbf ft)
2 SETUP
2
.
Loctite ® 2701™
Loctite ® 2701™
3