Installing The Refrigerator - GE G6S28TSLSS Owner's Manual

INSTALLING THE REFRIGERATOR

REMOVE THE FREEZER DOORS (if needed)
1
NOTE:
A. Starting with the left-hand door, use a 1/4"
nut driver to remove the screw from the top
hinge cover, and then remove the cover.
Hinge
Cover
Screw
B.
hinge cover by pressing the release catch on
the wire harness connector and pulling the
ends apart.
NOTE: there are 2 wire harness connections
under the left-hand top hinge cover, and 1
wire harness connection under the right-hand
top hinge cover.
Release
Catch
Green Ground
Screw
C.
screws from the top hinge. NOTE:
remove the green ground screw.
49-60765
Installation Instructions
D. Lift up on the top hinge until the hinge
then gently pull the wires and wire harness
connector through the hinge pin. NOTE:
not tug on the wires or connector(s) as you
pull them through the hinge pin.
Top Hinge
Screws
E.
door off of the center hinge pin. Place the
door on a soft, covered surface to avoid
damage to the finish.
F. Tape the hinge to the top of the refrigerator
cabinet to avoid possible damage to the
cabinet finish, the hinge itself or the ground
wire which is still attached.
Ground
Wire
G.
right-hand
17