Invacare Aquatec Ocean User Manual page 13

WARNING!
Risk of injury due to damaged backrest buckles!
Check for secure fastening of the backrest
buckles each time the product is maintained or
reconditioned.
– Check all buckle clips for secure fastening by
closing the buckles and pulling on both ends.
– Replace the backrest/backrest buckles if a
buckle opens under the applied force.
Adjusting the height of the armrests
IMPORTANT!
– Adjust the height of the armrests to suit the
user.
– Change the height of the armrests evenly on
both sides.
– Set the height of the right and left armrest in
the exact same manner.
1552757-G
1. On the backrest cover, open the buckle of the belt that
passes on the inside of the backrest frame.
2. On the backrest cover, open the buckle of the belt C
that runs above the armrest.
3. Pass this belt on the inside of the backrest frame and
re-close.
The nuts are inserted loosely in the retaining clamp
and can fall out.
4. Unscrew the screws B of the armrest bracket A using
the Allen key supplied.
5. Remove the securing clamp D with the nuts from the
inside of the backrest frame.
6. Remove the backrest bracket A with the armrest and
move it upwards.
The smaller hole serves to fix the retaining clamp.
7. Insert the screws in the armrest bracket and guide them
through the holes in the backrest frame.
8. If required, put the nuts back into the retaining clamp.
9. Place the retaining clamp on the backrest frame so
that the fixing on the retaining clamp projects into the
smaller hole.
10. Turn the screws in the nuts and tighten.
11. Pass the belt of the backrest cover that is still open on
the outside of the backrest frame, close and tighten
all belts.
Setup
13