Network Settings Menu; System Setup: Basic Menu - BenQ HT5550 User Manual

Network Settings menu

• Wired LAN: See
• AMX Device Discovery: When this function is On, the projector can be
• Network Standby: This menu provides basic and advanced settings for network
LAN Settings

SYSTEM SETUP: BASIC menu

Language Sets the language for the On-Screen Display (OSD) menus.
Splash Screen Allows you to select which logo screen will be displayed during projector start-up.
Allows the projector to turn off automatically if no input signal is detected after a
Auto Off
set period of time to prevent unnecessary waste of lamp life.
Direct Power Allows the projector to turn on automatically once the power is fed through the
power cord.
On
• Menu Position: Sets the On-Screen Display (OSD) menu position.
• Menu Display Time: Sets the length of time the OSD will remain active after
Menu Settings
• Reminder Message: Sets the reminder messages on or off.
Renames the current input source to your desired name.
Source
On the Source Rename page, use / / / , and OK to set the desired
characters for the connected source item.
Rename
When done, press BACK to save the changes and exit.
Auto Source Allows the projector to automatically search for a signal.
BenQ Network Projector Operation
detected by AMX controller.
control when the projector is in standby mode.
• Enable Network Standby Mode: Selecting On will keep the projector at a
lower power consumption than it is on while the projector is available for
network control. If selecting Off, the projector disconnects from network.
• Auto Disable Network Standby Mode: If Enable Network Standby
Mode is set at On, you can decide a time period in this menu to disable the
network standby function when there is no network activity occurs. Selecting
20 min/1 hr/3 hr/6 hr sets the projector to switch to non-network standby
status after that period of time. Selecting Never will always keep the
projector connected for network control.
your last key press.
Guide.
Menu operation 35