Sony HDVF-L10 Operation Manual page 21

g Tally indicator
Lights up in the following cases.
• When a red tally signal is input to the camera
• When the REC START button on the camera,
VTR button on the lens, or VTR button on the
remote control unit is pressed to start recording
When an abnormality occurs, the tally indicator
flashes to indicate a warning.
You can adjust the brightness using the TALLY
switch on the front panel. If not used, set the
TALLY switch to the OFF position to disable the
indicator.
h PEAKING control
Turn this control clockwise to adjust the picture
sharpness and make focusing easier. This control
has no effect on the output signals of the camera.
i CONTRAST control
Adjusts the contrast of the screen. This control
has no effect on the output signals of the camera.
j BRIGHT control
Adjusts the brightness of the screen. This control
has no effect on the output signals of the camera.
k TALLY switch
Controls the tally indicator.
HIGH: The tally indicator brightness is set to
high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
l ZEBRA (zebra pattern) switch
Controls the zebra pattern display as follows.
ON: Display a zebra pattern.
OFF: Do not display a zebra pattern.
m DISPLAY switch
Switches the DISPLAY indication ON/OFF and
switches the marker indication ON/OFF when the
camera's marker indication is set to "ON."
Notes
• The behavior when the DISPLAY switch is operated
will vary depending on the connected camera.
• A mismatch between the DISPLAY switch on/off state
and actual on/off operation may occur, depending on
the camera settings.
Operating the switch quickly as follows switches
the LCD display mode between full-screen
display mode and reduced display mode.
ON → OFF → ON → OFF
or
OFF → ON → OFF → ON
n MIRROR switch
The image display on the screen becomes
reversed horizontally or vertically when the
viewfinder barrel is raised up or rotated. Use this
switch to control the image display in such
situations.
L/R: Reverse the image horizontally.
OFF: Do not reverse the image.
B/T: Reverse the image vertically.
o Viewfinder cable
p Microphone holder
Screen display mode and indicators
You can switch the display mode of the LCD
screen between the following modes using the
DISPLAY switch.
Full-screen display mode
Displays the camera image so that it fills the LCD
screen display. The TALLY and other indicators
are superimposed on the camera image. Use this
mode when the resolution of the displayed image
is more important.
M
A
G
Names and Functions of Parts
M
A
G
21