System Start-Up; Initial Operation - Barco Iosono Core R9801500 Installation And User Manual

4. SYSTEM STARTUP
4.1

Initial Operation

Initial Operation
Your IOSONO CORE consists of electronic parts that may be sensitive to variations in temperature and humidity. Such variations
could appear with changing the place of installation or by leaving the device unused for a longer period of time.
To avoid harm to the device, always leave your device unpowered for a while. This should climatize the IOSONO CORE and its
hardware components to a normal working condition.
Initial Connection
Depending to your device hardware configuration, IOSONO CORE consists of single or redundant power supply component. Before
powering your device ensure each main inlet has been connected to your local power circuit orderly and in consideration of local
law and technical policies.
Please note: In case of local power circuit failure, redundant power supply will only get effective when inlet of redundant power
supply is orderly connected to a redundant local power circuit.
Based on your application connect all needed audio and data connections to the system now. A description of the device connectors
could be found at image 3-2. For proper operation always ensure sufficient connections. Always use cables and connectors that
matches your applications need with respect to type, dimension and quality.
Power On
systems featuring redundant power supply, please activate each of both power switches available.
Deactivate each main power switch if system is unused for longer period of time. Always deactivate each main power switch before
disconnecting the system from local power circuit.
Your IOSONO CORE is now ready to be started. In order to power on IOSONO CORE, please push the power button like shown at
Figure 3.1. The power button is now illuminated, indicating device is powered and running.
4.2 Basic System Control
About
Your IOSONO CORE is controlled via control software named "Control Client". The Control Client connects a MS Windows computer
remotely to the IOSONO CORE processor. For installation details, please refer to the Quick Start Guide that has been delivered
with your product.
Connect to IOSONO CORE Control Unit or to Easy Control by pushing the button respectiveley. The Control Unit gives you an
extended access to available configurations of the IOSONO CORE. The Easy Control gives you access to the most important con-
figurations and preset controls. All settings of Easy Control are accessible using IOSONO CORE touch interface (image 3-1).
4.2.1 Get System Control
Get System Control
1. Set up a network connection between the remote computer and the IOSONO CORE (Main Port). Configure the remote com-
puter's network interface IP adress to the same network as the IOSONO CORE. By factory default, device network is set to be
IP 192.168.1.1, Network mask: 255.255.255.0.
For example: Static IP of remote computer is 192.168.1.2.
2. Start the Control Client at your remote computer. Connect to the target device using the corresponding target IP address.
R5906746 IOSONO CORE 08/05/2017
4. System Startup
7