Bushnell Trophy Xtreme Instruction Manual page 5

USING THE TRIPOD / CAR WINDOW MOUNT
• Unfold the legs fully and set the tripod on a stable, level
surface such as a table or the ground.
• Make sure the upper section of the tripod is level and securely
attached to the top plate (A) of the lower section, by tightening
the C-clamp bolt (B).
• Turn the mounting screw knob (C) to attach the scope's
mounting base securely to the tripod platform (D) (do not
overtighten).
• Twist the pan/tilt handle (E) counter-clockwise to loosen it, tilt
the tripod head until the mounting platform is level with the
ground, then twist the handle clockwise to tighten it.
• To tilt the scope vertically, twist the pan/tilt handle counter-
clockwise to loosen it first, then tilt the tripod head up or down. To pan the scope left or right,
use the pan/tilt handle to rotate the tripod platform. To raise or lower the center column,
loosen the column lock (F), slide the column to the desired
height, and retighten the column lock knob.
• The top section of the tripod may also be used as a car window
mount. Loosen the C-clamp bolt (B), and remove the top
section from the tripod plate. Roll down your window partially,
leaving enough of it up to place the C-clamp on, with the bolt
knob facing you. Tighten the bolt knob to secure the mount in
place, being careful not to cause damage to the window (avoid
D
C
E
B
A
Note: appearance
and features of
F
tripod are subject
to change.
Car Window Mount
(removed from tripod)
B
5