Recording Proxy Data To Memory - Sony PDW-510P Operation Manual

3
Turn the MENU knob to scroll to the OUTPUT page.
Alternatively, in the CONTENTS page, select
"OUTPUT".
The OUTPUT page appears.
4
Turn the MENU knob to select "LIVE LOGGING",
and then press the MENU knob.
U01 OUTPUT
LCD BRIGHT <L>
LCD BRIGHT <H>
LCD COLOR
i.LINK MODE
PB WIDE ID(IMX) :
REAR BNC OUT SEL:
LIVE LOGGING
5
Turn the MENU knob to display "ON", and then press
the MENU knob.
The camcorder enters Live Logging mode.
6
Start recording in the normal way, by pressing the
REC START button or the VTR button on the lens.
Notes
• In Live Logging mode, you cannot set the F-RUN/SET/
R-RUN switch to SET to make time code settings. To
make time code settings, first exit Live Logging mode.
• During Live Logging operations, the time code
generator run mode is always F-RUN, regardless of the
setting of the F-RUN/SET/R-RUN switch.
• In Live Logging mode, you cannot set the PRESET/
REGEN/CLOCK switch to REGEN to read time code
from the disc and generate consecutive time code.
• The Picture Cache and Interval Rec functions are not
available in Live Logging mode.
Even if you turn these functions on, they are turned off
when the camcorder enters Live Logging mode.
3-2-11 Recording Proxy Data to
Memory Cards (With CBK-
PC01 Installed)
1) This is supported from firmware version 1.4 and PDZ-1 version 1.4.
When the optional CBK-PC01 memory card reader is
installed on this unit, you can save proxy AV data and
metadata (this chapter refers to both types of data as
"proxy data") for the clip being recorded or the clips on the
disc to a memory card (or "Memory Stick") inserted into
the CBK-PC01.
You can then insert these memory cards into a computer
with the PDZ-1 Proxy Browsing Software installed to
review the proxy AV data and modify or add metadata
58
3-2 Recording
TOP
: 0
: 0
: 0
: AV/C
THROU
VBS
: OFF
1)
(titles, comments, essence marks, etc.). You can also
create clip lists.
Note
Proxy data cannot be recorded to a "Memory Stick"
inserted into the camcorder's "Memory Stick" slot.
Usable memory card or "Memory Stick" types
Refer to the CBK-PC01 Installation Manual for
information on the types of memory card and "Memory
Stick" that can be used with the camcorder.
Note
Never remove a memory card while it is being accessed
(while the camcorder's ACCESS indicator is lit). Doing so
can corrupt the data on the memory card and render the
card unusable.
To record proxy data to memory cards in
synchronization with disc recording
With the CBK-PC01 installed on this unit, proceed as
follows.
1
Insert a memory card into the PC card slot.
2
Check the memory symbol (see page 60) and the
remaining memory display (see page 60).
Note
You cannot record proxy data to a memory card if you
start recording before the memory symbol and
remaining memory display appear. Especially just
after inserting a memory card and after powering the
camcorder on, it may take some time for the memory
card to be recognized.
3
Check to be sure that there is enough remaining
memory, and then press the REC START button or the
VTR button on the lens to start recording in the normal
way.
Proxy data is recorded in synchronization with
recording to the disc.
Notes
• Never remove the battery pack or the power cord during
recording to the memory card (while the camcorder's
ACCESS indicator is lit). Recording processing will not
finish normally, which means that the clip proxy data
recorded immediately before the interruption will be
lost.
• If the remaining memory on a memory card is exhausted
during recording, the message "MEM REC NG!"
appears. The clip proxy data that was being recorded
immediately before the message appeared is lost.
If this occurs, exchange the memory card, refer to the