Miele FNS 37402i Operating And Installation Instructions page 70

Installing the appliance
 Push the appliance into the niche
until the covers of the fixing brackets
at the top and bottom touch the front
edge of the side walls of the housing
unit.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.
–  16 mm thick housing unit walls:
The spacers should touch the front
edge of the housing unit side walls at
the top and bottom.
–  19 mm thick housing unit walls:
The front edges of the top and
bottom hinges should be flush with
the front edge of the housing unit
side wall.
70
On furniture with door fittings (e.g.
stubs, seals etc.)
The dimension of these must be taken
into account when making sure there
is a gap all round of 42 mm.
 Pull the appliance forwards by the
appropriate dimension.
 Check again to make sure there is a
gap of 42 mm to the front edges of
the door fittings.
Useful tip: If possible, remove door
fittings and push the appliance into the
niche until all fixing brackets at the top
and bottom are in line with the front
edge of the housing unit side wall.
 Align the appliance on both sides by
altering the adjustable feet using the
spanner supplied.