Advertisement
There shall be a Direct Thru (output) connector consisting of a male XLR jack.
The output of this jack shall be switchable between just Ch. 1 input and a Mix of Ch 1 and Ch 2. There shall be a
filtered high-pass output providing a crossed over signal to a satellite speaker.
The system power amplifiers shall have an unfiltered frequency response of 20 Hz to 20 kHz which deviates no
more than +1, -3 dB up to rated power, hum and noise better than 90 dB below rated power, and THD and IMD
typically of less than 0.1%.
The woofer amplifier shall be capable of 575W continuous into a 8 ohm nominal load, and 1,150W peak avail-
able power, and incorporate signal compression and limiting.
The input signal shall be electronically divided into high frequencies and low frequencies by a Linkwitz-Riley
fourth order slope line-level crossover, with crossover frequencies user selectable from 100 Hz, 110 Hz or 120
Hz. The low frequencies shall be processed to provide bass boost, subsonic filtering and overall response shap-
ing, and the high frequencies shall be made available either flat or equalized for response-shaping via user select-
able EQ presets.
The enclosure shall be constructed of 18 mm birch plywood with a textured black polyurethane coating. A pair
of 4-way inset handles shall be incorporated on the sides of the cabinet, and four sturdy rubber feet for floor
standing use.
A full-length powder-coated metal grille shall be provided for woofer protection. The cabinet shall incorporate a
threaded pole mount for a pole to be used for a satellite speaker, and the threaded pole shall be included.
The outside dimensions shall be: 26.38" (67.0 cm) tall x 22.84" (58.0 cm) wide x 24.38" (62.1 cm) deep, and the
weight shall be 85 lbs. Power requirements shall be: 200 Watts nominal, 120 VAC, 50/60 Hz Domestic and 220-
240 VAC, 50/60 Hz (Export). The loudspeaker system shall be called a Peavey® SP® 118P Sub.
Advertisement
