Advertisement
Configure?
Push Select
This is an overview display that is not directly edited.
Entering the configuration menu directs the user how to properly set up and connect the system.
First Screen displayed after pushing Configure?
Crossover Sub to
Proc. Out:110 Hz
Rotate knob to select a different crossover frequency
110 Hz is the default selection, other choices are 100 Hz and 120 Hz.
Once selection made and the knob is pushed, next screen:
Connect Mixer to:
Sub input.
Push knob, next screen:
Sub Proc. Out to
Satellite Spkr
Push knob to go back to the main menu.
With the mixer output (sound source) connected to the subwoofer, all of the system adjustments will be made
using the SP Sub DSP module. The User processing choices as in the SP® 2P/4P, such as the 9 band GEQ, will
not be used, the SP® 2P/4P
should be in Flat mode.
The hi-pass filter on the SP® 2P/4P is unchanged from it's full range setting, because the Sub performs the cross-
over functions.
Program EQ: Displays current EQ selection (EDM preset is the default on 1st time power up)
(Presets)
EDM, Voice, Rock, DJ .......
The program EQ selection is applied to the Graphic Equalizer and Bass enhancer.
"Custom" is displayed if GEQ has been adjusted by the user.
The last preset used, including a Custom one, is what will load the next time the SP® Sub is
Delay:
Current delay time
Adjust screen 0 to 150 msec also Feet and Meters
Graphic EQ: Current settings 9 Bands +/- 12 dB at ISO octave centers (63Hz to 16 kHz)
Press the encoder to enter the screen to adjust the GEQ. Turning the encoder selects the frequency band to be
adjusted. Press the encoder to adjust that band. Pressing the encoder again returns to the band select mode. To
exit to the main menu, turn the encoder past the 16 kHz band to the X and Exit will appear. Press the encoder
to exit.
Sub Polarity:
Normal (Default Selection)
Inverted
powered up.
Advertisement
