Selecting An Approach - Garmin GTN 750 Pilot's Manual Upgrade Supplement

6.4
Foreword
NOTE: In software v6.21 and later, the pilot may load an alternate approach
Getting
during a missed approach procedure. The GTN retains all missed approaches
Started
in the flight plan.
Audio &
Only one approach can be loaded at a time in a flight plan. If an approach
Xpdr Ctrl
is loaded when another approach is already in the active flight plan, the new
Com/Nav
approach replaces the previous approach. The route is defined by selection of an
approach, the transition waypoint, and a runway.
FPL
Direct-To
Proc
Available Departures
Charts
Available Arrivals
Wpt Info
Map
Available Approaches
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
NOTE: If using Descent VNAV, verify that the altitudes for the selected
procedure match the charted or ATC cleared altitudes and are appropriate
for the airframe type.
System
Messages
Symbols
Appendix
6-10
Index

Selecting an Approach

1. Touch the PROC key on the Home page. The Approach, Arrival,
and Departure fields will be dashed until a selection is made.
Touch To View
Touch To View
Touch To View
Figure 6-12 Procedures Selection Window
2. Touch the Approach key on the Procedures page to select
an approach for the destination airport. Confirm that the
intended airport is shown or touch the Airport key and select
the desired airport.
GTN 725/750 Pilot's Guide 190-01007-03 Rev. Q