Creating Input And Output Modules For Et 200Mp - Siemens SIMATIC S7-1500 Getting Started

Software section
3.1 Creating the project and hardware
3.1.8

Creating input and output modules for ET 200MP

Introduction
In the following section, you will create the input and output modules for ET 200MP.
Procedure
1. Open the device view of ET 200MP.
2. Open the "DI" and "DI16 x DC24V HF" folders in the hardware catalog.
3. Drag-and-drop input module "6ES7 521-1BH00-0AB0" to slot 2 of the rail.
4. Open the "DQ" and "DQ16 x DC24V / 0.5A ST" folders.
5. Drag-and-drop output module "6ES7 522-1BH00-0AB0" to slot 3 of the rail.
Result
You have created the input and output modules.
46
Getting Started, 05/2014, A5E03981761-AC
S7-1500