Fxo Configuration - Avaya SR 2330 Task Based Manual

AG 2330 Installation Reference
To configure a T1/E1/PRI port on the gateway, type the following commands:
# Configure a PRI T1 link to connect to PSTN switch.
# Assuming the following:
# • All numbers start with 408 (dest-pattern 408.%) are routed to PRI.
# • The switch type is 5ESS.
# • The PRI link is connected to first port of first slot.
interface bundle pri1
link pri_t1 1/1 voice
isdn
side USR
switch-type primary-5ess
activate
exit
exit
dial-peer voice pots 10
destination-pattern 408.%
port 1/1
# Send all digits
forward-digits all
no shutdown
exit

FXO Configuration

In equip the FXO port, several parameters need to be configured.
 The Port Location on the gateway
 The Signal – loop-start or ground-start
 The Ring Number - number of rings after which the FXO goes off-hook.
range is 1-10
 The Station Number – number of the associated PSTN trunk
 Where to Route Inbound PSTN Calls – extension to route inbound calls
 Pattern to match for Inbound SIP Calls – dial pattern to route to FXO
To configure FXO ports on the gateway, type the following commands:
# Configure a FXO link to connect to PSTN switch.
# Assuming the following:
# • Ensure port numbers are correct as this is reusing the PRI ports.
# • All numbers start with 408 (dest-pattern 408.%) are routed to FXO.
# • The FXO link is connected to first port of first slot of the SR.
voice-port 1/1
signal loop-start
ring-number 2
caller-id enable 1
station number 4082655745
no shutdown
# Calls into this FXO port are routed to this extension
connection plar 1000
exit voice-port
dial-peer voice pots 10
18 NN40010-551 Issue 1.3 SCS 4.0