Maintenance information and precautions
Ajusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to OFF.
(2) Eject the tape from your camcorder, then disconnect any connecting cable from
your camcorder.
(3) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL on
your camcorder, then keep pressing DISPLAY/TOUCH PANEL for about five
seconds.
(4) Follow the procedure below using an object such as the corner of the "Memory
Stick" supplied with your camcorder.
1 Touch
2 Touch
3 Touch
CALIBRATE
Note
If you do not press the right spot,
corner. In this case, start from step 4 again.
at the upper left corner.
at the lower right corner.
in the middle of the screen.
CALIBRATE
always returns to the position at the upper left
CALIBRATE
141