Table of Contents
Advertisement
www.seagate.com
Figure 6 Nytro XP6302 Card LED Diagram
The following table shows LED Descriptions:
Table 2 Status Indicators on a Running System
Name
Color
Life
Green
Yellow
Red
Status
Green
Yellow
Red
Seagate Nytro XP6302 Flash Accelerator Cards User Guide, Rev. E
On, steady – Card has sufficient life remaining for programming and erasing the Flash memory. No
action required.
On, steady – Card has approximately 10% or less of life remaining for programming and erasing the Flash
memory. Plan for replacements.
On, steady – Card has no program or erase cycles left. Data can be read, but writes are at risk. Back up data and
copy to a new Nytro XP6302 card.
On, steady – Normal.
On, blinking – Lets the user locate a specific Nytro XP6302 card in a rack of servers.
On, steady – Warning. One of the following conditions applies:
Temperature warning. If this condition persists, you might damage your Nytro XP6302 card. Increase cooling
for the card or shut down your system to prevent damage.
Other component issues: Run the list and health commands in the management utility to determine which
component has an issue.
On, blinking – Firmware fault code:
Run the management utility to determine which component has an issue.
If no information appears, reboot the system and retry.
If no information appears, contact
On, steady – One of the following conditions applies:
At least one SSD has exceeded its temperature.
Failed RAID volume (DD mode).
No RAID volume is configured (DD mode).
Backup power store failed.
Other component issues: Run the list and health commands in the management utility to determine which
component has an issue.
If no information appears, reboot the system and retry the utility.
LED Description
Seagate Technology Support
Nytro XP6302 Card Characteristics
Services.
14
Advertisement
Table of Contents
