Threshold - Cisco Nexus 7000 Series Command Reference Manual

threshold

threshold
To set the class of service (CoS) for a Cisco NX-OS IP Service Level Agreements (SLAs) Ethernet
operation, use the threshold command. To return to the default value, use the no form of this command.
Syntax Description
milliseconds
Command Default
5000 ms
Command Modes UDP echo configuration mode (config-ip-sla-udp)
UDP jitter configuration mode (config-ip-sla-jitter).
Command History Release
6.1(1)
Usage Guidelines
The value specified for this command must not exceed the value specified for the timeout command.
The threshold value configured by this command is used only to calculate network monitoring statistics
created by a Cisco NX-OS IP SLAs operation. This value is not used for generating Simple Network
Management Protocol (SNMP) trap notifications. Use the ip sla reaction-configuration command to
configure the thresholds for generating IP SLAs SNMP trap notifications.
This command does not require a license.
Examples
This example shows how to configure the threshold of the IP SLAs UDP echo operation to 4000:
switch(config)# ip sla 1
switch(config-ip-sla)# udp-echo 172.16.1.176 1
switch(config-ip-sla-udp)# threshold 4000
switch(config-ip-sla-udp)# ip sla schedule 1 start-time now life forever
switch(config)#
Related Commands Command
ip sla
ip sla
ethernet-monitor
Cisco Nexus 7000 Series NX-OS IP Service Level Agreements (SLAs) Command Reference
1-56
threshold milliseconds
no threshold
Length of time required for a rising threshold to be declared, in milliseconds
(ms). The range is from 0 to 60000. The default is 5000.
Modification
This command was introduced.
Description
Begins the configuration for an IP SLAs operation and enters IP SLA
configuration mode.
Begins the configuration for an IP SLAs auto Ethernet operation and enters
IP SLA Ethernet monitor configuration mode.
Chapter 1 Cisco Nexus 7000 Series IP SLAs Commands
OL-27555-03