Sony CCD-TR57 Operating Instructions (primary manual) Operating Instructions Manual page 28

Changing the mode settings
Items for CAMERA mode only
D ZOOM* <ON/OFF>
• Select ON to activate digital zooming.
• Select OFF to not use the digital zoom. The camcorder goes back to 16x
(CCD-TR57/TR67/TR87) or 18x (CCD-TR97/TR917/TR940) zoom.
16:9WIDE* <OFF/CINEMA/16:9FULL>
• Normally select OFF.
• Select CINEMA to record in CINEMA mode.
• Select 16:9FULL to record in 16:9FULL mode.
STEADYSHOT* <ON/OFF> (CCD-TR87/TR97/TR917/TR940 only)
• Normally select ON.
• Select OFF to release the SteadyShot function.
N.S.LIGHT* <ON/OFF> (CCD-TR97/TR917/TR940 only)
• Normally select ON.
• Select OFF to not use the NightShot Light function.
WIND <ON/OFF> (CCD-TR917/TR940 only)
• Select ON to reduce wind noise when recording in strong wind.
• Normally select OFF.
ORC TO SET*
Select this item to automatically adjust the recording condition to get the best possible
recording.
If you have already performed this function, "ORC ON" is displayed.
CLOCK SET*
Reset the date or time.
AUTO DATE* <ON/OFF>
• Select ON to record the date for 10 seconds after recording has started.
• Select OFF to not record the date.
DEMO MODE* <ON/OFF>
• Select ON to make the demonstration appear.
• Select OFF to deactivate the demonstration mode.
Notes on DEMO MODE
•DEMO MODE is set to STBY (Standby) at the factory and the demonstration starts
•You cannot select DEMO MODE when a cassette is inserted in the camcorder.
•If you insert a cassette during the demonstration, the demonstration stops. You can
•When NIGHTSHOT is set to ON, "NIGHTSHOT" appears in the viewfinder and
To look at the demonstration at once
Eject the cassette, if inserted. Select ON of DEMO MODE and erase the menu
display. The demonstration will begin.
When you turn off the camcorder once, DEMO MODE automatically returns to STBY.
28
about 10 minutes after you set the POWER switch to CAMERA without inserting a
cassette.
Note that you cannot select STBY of DEMO MODE in the menu system.
start recording as usual. DEMO MODE automatically returns to STBY.
the demonstration does not start (CCD-TR97/TR917/TR940 only).