Sony 300PF Operating Instructions Manual page 40

Using Accessories
To connect a WRR-810A/860A
Attach the WRR tuner fitting (not supplied) (Part No.
A-8278-057-A) to the rear of the camcorder as shown
in the following figure.
1
Pass a screwdriver through the holes and tighten
the screws .
2
Loosen the adjustment screws.
3
Adjust the metal fitting position for a battery
pack to be attached, and tighten the adjustment
screws to fix its position.
Using an external audio system
Connect an audio mixer or other external audio system
component to the AUDIO IN CH-1/CH-2 connector as
shown below.
40
Chapter 2 Fitting and Connections
2,3
4
1 4
4
Attach the holder kit (two fittings and four screws,
supplied with the tuner) to the WRR tuner fitting
(one for the upper position and the other for the
lower position).
5
Mount the tuner on the WRR tuner fitting.
For details about the WRR tuner fitting (Part No. A-8278-
057-A), contact your Sony dealer.
AUDIO IN (CH-1/CH-2) switches: Set to REAR.
CH-1
AUDIO IN
FRONT
VJ MIC
WRR
REAR
Input selection switch: Set to LINE.
LINE
AUDIO IN
CH-1/CH-2
5
WRR-810A/860A
CH-2
+48V ON
MIC
To audio mixer, etc.