Location and Function of Parts and Controls
Front Panel
Headphone
Headphone
Busy
Jack
Volume
Indicator
Control
Rear Panel
ACTIVE TERM
TEST
ID SELECT
AUDIO OUT
R GND L
0 1 2
INTERFACE CONNECTOR
Jumper block for SCSI bus
Audio output connector
6
Location and Function of Parts and Controls
Disc Drawer
Emergency
Eject
Eject Hole
Button
DC INPUT
5V±5% GND 12V±10%
Power-in connector
SCSI bus interface connector
Precautions
Installation
Avoid placing the drive in a location subject to:
– high humidity
– high temperature
– excessive dust
– mechanical vibration
– direct sunlight.
Only horizontal drive operation recommended, not vertical or tilted.
Operation
Do not move drive during operation, it may cause an error.
Avoid sudden temperature changes, condensation may form inside
the drive. Should ambient temperature suddenly change, wait at
least 1 hour before turning off power. Operation immediately after
temperature change may cause a malfunction.
Transportation
Keep the original packing materials for future transport of the drive.
Hardware Installation
Installing the Drive Unit into the Computer
This example assumes an IBM-PC/AT* compatible computer,
a SCSI adapter card and a SCSI interface cable (50 pin flat) are at-hand.
Getting Started
Assure SCSI adapter is operational before installing CD-R/RW drive.
Prepare the necessary parts and tools not supplied:
– a screwdriver
– Two mounting rails if computer has mounting racks.
Precautions/Hardware Installation
7