Step 6: Connecting The Drive; Step 7: Mounting The Drive; Step 8: Connecting The Power Cable - Sony CD-R/RW User Manual

Step 6: Connecting the Drive

Attach flat SCSI cable to connector at rear of CD-RW drive.
CD-R/W Drive Unit
Interface Connector
Audio Out
Connector
Notes:
The 50 pin flat SCSI cable must be firmly attached with its red edge
(Pin 1) positioned next to the power supply connector.
If computer has a Sound Card, an Audio Cable may be connected to the
rear of the CD-RW drive. Contact a local dealer if cable is required.
12 Hardware Installation
Pin 1
Power Supply Connector
Red Edge
Audio
Cable

Step 7: Mounting the Drive

SCSI
Flat Cable

Step 8: Connecting the Power Cable

Insert the CD-RW drive into computer front as shown, routing cables
accordingly. Secure drive to frame with appropriate screws.
Mounting Screws
Audio Cable
Note:
Slide rails (not included) may be necessary if you cannot secure CD-RW
drive. Refer to your computer's User's Guide for more information.
Locate an available power supply cable, within computer, and connect it to
the rear of CD-RW drive as shown.
Power Supply
Connector
Power Supply Cable
Note:
The power supply cable connector is designed to fit one way, do not force
it upside down, this could damage drive and void the warranty.
Flat Cable
DC INPUT
+ - + -
5V 5% GND 12V 10%
Hardware Installation 13