Advertisement
5
3mm
Battery Bell Installation
• Drill a hole, fit a wall plug and screw.
• Leave a gap of 3mm between the screw head and wall.
• Locate the keyhole slot on the back of the chime unit over the
screw.
Important:
• Make sure new set of alkaline battery is used in first
time operation.
• Make sure the batteries are installed properly and
the battery polarities match the internal markings.
• Change the frequency digital codes if door chime
activate intermittently for no reason at all (see
digital set up).
• Do not use the Chime unit with transformer
6
100m
Operation
• Press the button on the Push Button unit once, it sends a
wireless signal to the Door Chime and your Door Chime unit will
sound.
• Operate the Door Chime unit within the operation range, test it
before final installation.
Important
1. Do not mount either unit close to fireplace or expose to high temperatures.
2. Do not expose the Battery Bell unit to direct sunlight or moisture
3. Always use alkaline battery. Please dispose of old, defective batteries in an environmentally
friendly manner in accordance with the relevant legislation.
4. Make sure that no naked flame sources, such as lighted candles, should be placed on the unit.
5. The unit should not be exposed to dripping or splashing and no objects filled with liquids, such
as vases, should be placed on the unit.
6. CAUTION: Replace only with the same or equivalent type of battery that is recommended by the
manufacturer.
7. CAUTON: Make sure batteries are installed correctly as per the internal markings.
8. CAUTION: Danger of explosion if battery is incorrectly installed or replaced.
9. IMPORTANT: There are no serviceable parts in the units, do not attempt to repair it.
Trouble Shooting & User Hints
If the door chime unit does not sound, please check the followings:
a) Flat batteries in either Push Button or Battery Bell units - change the batteries.
b) Wrong battery polarity in either Push Button or Battery Bell units - re-insert the batteries.
c) Push Button and Door Chime units are not on the same operation codes - re-set the code (see
digital code set up).
d) Units are out of range - Operate the Battery Bell unit within the operation range.
Specification
Operating Temperature: -10C - +40C
Operating Distance: 100metre (330ft approx. - in open field & at suitable condition)
Digital Code: Total two hundred fifty six (256) possible digital codes
"Type R2 Device - device where the sound output is created by the initial operation of the control
and where the period of sound output continues for the designed duration irrespective of condition
of the control."
CH Byron Electrical Ltd
Byron House
34 Sherwood Rd, Astonfield
Bromsgrove, B60 3DR
UK
Tel: 0845 2301231
e: support@chbyron.com
w: www.chbyron.com
433MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
Advertisement
