Byron SX-15i Manual

Wire Free Battery Bell
Model SX-15i
1
Remove
Isolation
Strip
CR2032 3V
Lithium Battery
Push Button
• Open up the push button by pushing in the tab at the bottom
of the push with a small flat screwdriver.
• Remove the isolation strip from the battery compartment then
it is ready to use.
• When replacing the battery, ensure the battery polarity matches
the internal markings ("+" facing upwards), then press the
battery down so that it is sitting firmly in its compartment.
3
Signal Sent Indicator Light
Digital Code Set Up
• Press the Push Button once, a new operation code is generated
randomly and sent to the Door Chime unit.
• The Door Chime will sound to indicate that a new operation
code is registered and memorised.
2
UM-1
UM-1
"D"
"D"
R20
R20
Battery Bell
• Remove the front cover.
• Insert 2 x 1.5volt alkaline batteries ("D", UM1 & LR20
- not included) into the battery compartment, ensuring the
battery polarity match the internal markings.
• Snap the front cover back on then it is ready to use.
IMPORTANT: Not to be used with a transformer.
4
Push Button Installation
• Using the holes on the back of push button as a template, mark
the fixing position for the unit.
• Drill holes and fit wall plugs and secure the push button unit to
the wall with screws.
• Do not mount it on any metal surface or UPVC door frame.
Wire Free Battery Bell Kit
Push Button unit
Power: 1 x 3volt Lithium battery (CR2032 - included)
Door Chime unit
Power: 2 x 1.5volt alkaline batteries ("D", UM1 & R20 - not included)
Door Chime Operation
Press the button on the Push Button once, it sends a wireless signal to the battery bell unit and it
will sound. The sound will stop as soon as the melody ends. For repeat sound, press the button
again. Hold the button in will NOT repeat the sound.
Digital Code Set Up
The Door Chime kit is equipped with an advanced random and self-learning operation coding ability
therefore no setting is needed. Read the following instructions before use.
1. First time operation:
After battery installation on the Push Button and Door Chime units, press the Push Button once
and it will generate a new operation code randomly and send a wireless signal to the Door Chime
unit. The door chime unit will sound to indicate that new operation code is registered and
memorised.
2. Interference from a similar unit operating nearby:
a) Simply remove the batteries from the Push Button and Door Chime units and rest for 10
seconds, this will erase the memory.
b) Insert the batteries into the Push Button and the Door Chime units. Press the Push Button
once, it will generate a new operation code randomly and send a wireless signal to the Door
Chime and it will sound to indicate that new operation code is registered and memorised.
3. Front and back door Bell Push operation:
a) Remove the batteries from the Push Buttons (Front & Back Door) and Door Chime units and
rest for 10 seconds, it will erase the memory.
b) Insert the batteries into the Push Buttons and Door Chime units.
c) Press the front door Push Button once, it will generate a new operation code randomly and
send a wireless signal to the door chime unit and it will sound to indicate that a new operation
code is registered and memorised.
d) After, (within 2 minutes) press the back door Push Button once, it will generate a new
operation code randomly and send a wireless signal to the door chime unit and it will sound to
indicate that new operation code is registered and memorised. The door chime unit has the
ability to memorise both operation codes.
e) Test to ensure correct operation before final installation.
SX-15i