Installation and
Features
This section of the guide describes the following topics concerned with the installation,
setup, and operation of the DTP T DSW 4K series.
•
•
•
•
•
Mounting the Units
ATTENTION:
The DTP T DSW 4K series can be placed on a table, mounted in a rack, or mounted under
a desk or table.
Tabletop Use
Affix the included rubber feet to the bottom of the unit and place it in any convenient
location.
Mounting Kits
Mount the unit using any optional compatible mounting kit listed on the Extron website
(www.extron.com), in accordance with the directions included with the kit. For rack
mounting, see
UL Rack-Mounting Guidelines
The following Underwriters Laboratories (UL) requirements pertain to the installation of the
unit into a rack.
•
•
Mounting the Units
Front Panel Features
Rear Panel Features
Power Supply Wiring
Twisted Pair Recommendations for DTP Communication
•
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé
uniquement.
UL Rack‑Mounting Guidelines
Elevated operating ambient temperature — If installed in a closed or multi-unit rack
assembly, the operating ambient temperature of the rack environment may be greater
than room ambient. Therefore, consider installing the equipment in an environment
compatible with the maximum ambient temperature (TMA = +122 °F, +50 °C) specified
by Extron.
Reduced air flow — Installation of the equipment in a rack should be such that the
amount of air flow required for safe operation of the equipment is not compromised.
Extron DTP T DSW 4K Series • Installation and Operation
below.
3