Set-Up - Pace XR 3700 Manual

7. Set Up
A. XR 3500/3700 as a stand-alone inspection station
Place the XR 3500/3700 on a stable work platform of sufficient
capacity to adequately support the XR 3500/3700. The monitor used
to view the images should be placed on the work surface next to the
XR 3500/3700 and not on top of the XR 3500/3700, as it is not
designed to support a monitor and the monitor may fall.
Locate the foot pedal, composite video cable, and power cord. These
should be connected as shown in Figure 1.
The other end of the composite bnc cable should be connected to the
composite video input on the video monitor; a bnc-to-RCA converter
might be needed. The power cord should be connected to a properly
grounded 120 VAC power supply.
B. The XR 3500/3700 used with the TF 1700/2700 or IR3000 BGA/CSP
Rework Center
Place the XR 3500/3700 on a stable work platform of sufficient
capacity to adequately support the XR 3500/3700. The work platform
can be the same as the work platform supporting the TF 1700/TF2700,
or may be a separate one as long as it is close enough to allow for the
connection of the composite video cable to the PC.
Locate the foot pedal, composite video cable, and power cord. These
should be connected to the slots in the back of the XR machine
illustrated in figure 1.
Figure 1: The back of the XR 3500/3700
9