Table of Contents
Advertisement
Connecting the
MegaPlug Hub
To connect the Hub, it must be connected to a computer, plugged into a standard
wall outlet, and the Configuration Utility loaded on the computer.
Connecting the Hub
To use the Hub properly, if should be plugged into electrical outlets, and devices
(computers, printers, etc.) connected to them.
Connecting a Hub to a Computer
1. Get a Hub and one Ethernet cable.
2.
Insert one end of the Ethernet cable into the Ethernet port of the Hub.
3. Plug the Hub into a wall outlet.
☞
Note: Do not plug the Hub into a
protection. The Hub's network signal may not pass through
these devices.
4. Insert the other end of the Ethernet cable into an Ethernet port on the back of
a computer.
Connecting a Hub to a Router/Gateway
1. Get a Hub and one Ethernet cable.
2.
Insert one end of the Ethernet cable into the Ethernet port of the Hub.
3. Plug the Hub into a wall outlet.
☞
Note: Do not plug the Hub into a
protection. The Hub's network signal may not pass through
these devices.
4. Insert the other end of the Ethernet cable into an Ethernet port on a router/
gateway connected to a computer.
or power strip with surge
UPS
or power strip with surge
UPS
5
2
Advertisement
Table of Contents
