Table of Contents
Advertisement
Care and cleaning
Replacing the burner parts
Important!
When replacing the burners, make sure that the locating pin on the bottom of the brass
port ring is properly aligned with the locating pin slot on the top of the burner base.
Incorrect alignment will produce a potentially dangerous flame and poor burner performance.
Burner
Locating Pin
lines up into
this notch for
proper
placement
Burner not properly
aligned (see gap)
placed under
Burner properly
aligned (NO gap)
36
Replacing the oven light bulb
Important!
Use a 25 W G9 appliance light bulb for replacement. Do not use a standard light bulb in any
oven, the heat will break it.
1 Allow the oven (including the lamp cover and the bulb) to cool completely.
2 Remove any shelves that may get in the way.
3 Remove the door if the lamp will be hard to reach.
4 Turn the power supply to the range off at the main fuse or circuit breaker panel. If you don't
know how to do this, contact an electrician.
Important!
Failure to disconnect the range from the power supply may result in death or electrical shock.
5 See diagram below for location of oven light bulbs.
Burner
6 follow step by step instructions on next page for replacing the oven light bulb.
properly
the grate
Remove the lamp cover and turn it counterclockwise to unscrew.
6 Remove the faulty bulb and replace with a new 25 W G9 appliance light bulb.
7 Replace the lamp cover: turn it clockwise to tighten.
8 Turn the power supply to the range back on at the main fuse or circuit breaker panel.
Care and cleaning
Two oven light bulbs located on
the right and left side of the oven
37
Advertisement
Table of Contents
