Removing And Replacing The Side Ladder Rack System - Caliber INDOOR Professional Range Series User Manual

36 inch,48 inch
Table of Contents

Advertisement

Care and cleaning
To re-install the oven door
1 Hold the door firmly in an approximately
halfway open position.
Push Lever Up to
Close Lever
3 Open the door fully and fully close the
levers on the left and right hinges up.
2 Insert the hinge tongues into the slots,
making sure that the bottom notches on both
sides drop into place as shown.
Push Lever Up to
Close Lever
4 Levers on the left and right hinges fully
closed upward, as shown, then close the
door.
34
Care and cleaning

Removing and replacing the side ladder rack system

To remove side racks
1 Remove any racks first. See section
'Positioning the racks for instructions.
To replace side racks
4 screws
2 Remove the 4 screws that attach the side ladder
rack system for the racks to side into the oven.
1 Supporting the ladder system with your hand
from underneath position the side rack until one
hole is aligned.
2 Insert the screw, but don't tighten. Align and
insert the remaining screws then tighten all.
35

Advertisement

Table of Contents
loading

Table of Contents